Belt Clip for Uniden SDS100 Scanner - Slide-On Replacement Clip, Compatible Aftermarket Part, Black PETG, 1 pc

Slide-on belt clip for the Uniden SDS100 handheld scanner. How it attaches: Put the round stud on the back of the scanner into the large round opening of the clip, holding the scanner at a slight angle, then slide the scanner down so the stud runs along the slot and locks behind the clip wall. To take the scanner off, slide it back up and lift it out. Slide the clip onto your belt through the gap at its open end. - Compatible with: Uniden SDS100 (the clip is short enough to sit above the SDS100's thick battery cover) - Your scanner needs its original belt-clip stud fitted on the back. The stud is not included. - Material: PETG, black, 3D printed. Fine layer lines are normal for this process. - Size: 21.5 x 49.2 x 25.0 mm (0.85 x 1.94 x 0.98 in). Belt slot 6 mm wide. - 1 clip per order. Please check your scanner model before ordering. Aftermarket part, not made by or affiliated with Uniden. Exterior shape (faceted top, chamfers, grooves): our own design. The stud keyhole, internal channel and belt slot follow "Uniden SDS100 Belt Clip" by brettbrady (thingiverse.com/thing:4621814, CC BY), a remix of "Uniden UH076SX Two Way Radio Belt Clip" by dislegal (thingiverse.com/thing:970567, CC BY-SA), re-modelled by us. Not endorsed by brettbrady or dislegal.

Belt Clip for Uniden SDS100 Scanner - Slide-On Replacement Clip, Compatible Aftermarket Part, Black PETG, 1 pc