Replacement side end caps (left and right) for the Yamaha DX7 synthesizer (original DX7 from 1983). For keyboards whose plastic end cheeks are cracked, broken or missing. What you get - 1 left and 1 right end cap. Each cap is 330 mm long, longer than the printer allows in one piece, so it comes in 2 printed sections plus a small joining key. - Printed in black PETG (FDM 3D printing). Fine layer lines are visible. The top edge of each cap is printed against the build plate for a smooth finish. Fit - The screw feet, the two locating pegs, the rear screw tab and the inside faces that sit against the keyboard follow the layout of the original end cap. - Each section has its own screw points, so the two sections are screwed to the keyboard separately. The key keeps them in line; a drop of CA glue or epoxy in the key slot is optional. - Screws are not included. Reuse the original screws. - Not for the DX7s, DX7 II, DX7 IID / IIFD (different end caps). - The DX9 shares the DX7 body, but this part has only been fitted to a DX7. Please compare it with your original cap before ordering. Design - Our own exterior: chamfered step line, pin line along the top edge, chamfered corners. It is not a copy of the Yamaha part. Installation 1. Remove the old cap (screws under the feet and at the rear tab). 2. Push the key into the slot of the rear section (glue optional), then slide the front section onto the key. 3. Fit the cap to the keyboard and tighten the original screws. Please check your model before ordering. Aftermarket part, not made by or affiliated with Yamaha. DX7 is a trademark of Yamaha Corporation and is used only to describe compatibility.