Jeep JL 3rd Brake Light Relocation Mount

You will need a M8-1.25 x 20mm bolt and nut. (Not supplied) https://a.co/d/0eKhaaic and https://a.co/d/0h3V3rS1 Stock Brake Riser Light Removal 1. Remove plastic lock from camera - T40 bit 2. Remove spare tire from mount - 22mm socket 3. Loosen the 8 bolts from spare tire carrier - 13mm socket 4. Remove the 7 bolts from front of brake light riser mount - T25 bit 5. Separate back half from front 6. Remove brake light wire from riser 7. Remove 4 bolts holding riser from tire carrier - T25 bit 8. Remove riser from Jeep 9. Remove 2 screws holding light to riser - T25 bit (will reuse these screws and light) 10. Unplug wire from light 11. Re-attach spare tire to mount New 3D Printed Mount Install 1. Route wire thru wheel how ever you want. 2. Use some double-sided adhesive with zip tie if you want to secure wire 3. Mount the light to your print using the two T25 screws. Open end of mount faces back. 4. Connect wire to light. Feed directly from back of mount. DO NOT feed wire up through hole. 5. Slide mount onto camera. Nubs inside round hole should fit into slots on sides of camera enclosure. 6. Tighten mount with T40 from toolkit OR if quick release, pull the lever out and tighten hex bolt. Once tight, twist the quick lever up to lock in.