EnvelopeJogger — JLF-82

Square up a small stack of photo envelopes before labeling or boxing. Two perpendicular fences and open finger cutouts make aligning loose envelopes easier. MEASURE FIRST Contact area 100×100 mm; fences 25 mm high. Larger envelopes may overhang. IN THE BOX 1 printed part in matte black PLA: jogger. No additional fasteners required. Subjects, camera, lights and accessories are not included. Printed and shipped on demand by Slant 3D. Shipping and taxes are calculated at checkout. USE Tap dry sealed envelopes against both fences on a desk. Remove the stack before transport; this is an alignment jig, not a case. Dry indoor use. Keep away from heat; inspect and smooth any rough print edges before use. CAD geometry and local slicing checked. Physical fit, finish, stability and durability have not been tested. Images are renders of the actual CAD. Design: João Lutz / JoaoLutzFilm, developed with AI assistance. Original CAD; no third-party mesh used.