Right End Cap for Thule Omnistor 5000 Awning Cassette – Replacement for Part 55 5453 00 – 1 pc, PETG White (Aftermarket)

Replacement right-hand outer end cap for the Thule Omnistor 5000 awning cassette (position of part no. 55 5453 00). - Fits: Thule Omnistor 5000 cassette, right-hand outer end cap. Not for the left cap, the inner cap, or the Omnistor 5002. Please compare with your old cap (side and shape) and check your awning model before ordering. - Material and colour: PETG, white. 3D printed, for outdoor use. - Size: approx. 85.9 x 138.9 x 57.2 mm (3.38 x 5.47 x 2.25 in). - Design: the inside (cassette profile, locating ribs, snap hooks, screw boss, slots) follows a community design that was shown fitted on the awning; the outside is our own design with thicker 2.4 mm walls, a 45° chamfered edge and a flat, grooved end face. - Installation: clips onto the end of the cassette in place of the original cap and is fixed with the screw from your old cap (screw not included). - Pack: 1 end cap. - 3D printed part: fine layer lines are visible on the surface. - Rendered images are computer graphics, not photos. Aftermarket part. Not made by, endorsed by, or affiliated with Thule. Fit-critical inner geometry derived from "End Cap Right Omnistore / Thule 5000" by 3DED (Cults3D), licensed under CC BY (Creative Commons Attribution). Changes: inner geometry redrawn layer by layer from the original; exterior redesigned (thicker walls, chamfered edge, flat grooved end face).