Elseben Modular Toothbrush Holder – Easy-Clean Bathroom Organizer – 5 Swappable Keyed Inserts: Toothbrushes, Razor, Toothpaste, Interdental – PETG

The toothbrush cup, solved. You know that cup by the sink — the one with the mystery gunk at the bottom that everyone pretends not to see? This holder replaces it. Everything gets its own slot, air flows everywhere, and cleaning takes seconds — no need to pull everything out and start over. KEY FEATURES • Keyed inserts — no wrong way. Every insert clips in with a satisfying click. Raised dots show the orientation at a glance, and the large center insert is keyed differently so it only fits its slot. • One slot for everything: 4 side slots (2 per side) + 1 large center slot. Reconfigure for your routine as it changes. • Easy to clean. Open-arch design: no cup bottom where water sits. Rinse it without emptying your whole setup. • Swap the look in seconds. Inserts pop out and click back in. • Built for bathrooms. Heavy-duty PETG base takes heat and humidity without warping; PLA inserts. • Printed to order and shipped from the USA. WHAT'S INCLUDED 1x base in matte black PETG 5x PLA inserts in matte teal blue: 2 toothbrush (each holds 2 brushes — slim handles fit up to 4), 1 razor, 1 interdental-brush caddy, 1 toothpaste (center) GOOD TO KNOW • Fits standard manual toothbrushes (nominal capacity: 4 brushes) and cartridge razors. Electric toothbrush bodies don't fit the standard insert — more insert types are on the way. • Photos show a hand-finished prototype (textured base, translucent teal and purple inserts). Production units: matte black base + matte teal blue inserts, smooth finish. • 3D-printed to order — fine layer lines are part of the look. • Care: quick rinse with warm (not hot) water. SIZE About 6.3" wide x 7.2" tall x 3.1" deep (160 x 183 x 80 mm).