1/4 in Gridfinity Hex Bit Holder (By Bandit Prints)

This design is by Bandit Prints and was found on Makerworld Under the "Creative Commons Attribution-Share Alike" License. The design was not modified. I don't know about you, but I have always had a drawer full of random hex bits that I have acquired over the years. It got to the point where it was faster for me to go to the store and buy a new bit than go searching for the one I owned. Eventually, I decided to do something about it. That was when I found this great 3d model by Bandit Prints on Makerworld. This model can hold 120 1/4 inch hex bits (I would advise against using all 120 spaces as it will be hard to get bits out). I also works with the gridfinity system so you can use it with the other gridfinity accessories (that I sell). Makerworld Link: https://makerworld.com/en/models/2870312-gridfinity-1-4inch-6-35mm-hex-bit-holder?from=search#profileId-3204385 License: https://creativecommons.org/licenses/by-sa/4.0/ *Photo also from Bandit Prints