35mm film strip holder for the Epson Perfection V600 Photo flatbed scanner. A replacement / alternative to the original 35mm film holder: holds two 35mm strips of up to 5 frames each, flat and in place for scanning. WHAT YOU GET - 1 base (167 x 219 x 4.3 mm) and 1 lid (118 x 219 x 7.5 mm), 3D printed in black PLA. - Magnets are not included (see below). COMPATIBILITY - Epson Perfection V600 Photo. - The original designer reports it also works with the V550. Other models have not been checked by us. - 35mm film strips only (negative or positive, up to 5 frames per strip). Not for mounted slides, 120 or 110 film. - Please check your scanner's model number before buying. HOW TO USE 1. Remove the document mat from the scanner lid. 2. Lay the base on the glass with the end that has the two short posts and the wide flat tab at the positioning end, as in the photo. Do not cover the calibration area. 3. Lay the strips into the channels, shiny base side down, on the ledges beside the windows. 4. Put the lid on (fluted side up). Its ridges hold the film flat. 5. Scan in Film mode. If frames are not detected automatically, use Professional Mode and select them in the preview. GOOD TO KNOW - Black on purpose: light-coloured plastic reflects light into the scan. - 12 pockets per part for optional 6 x 2 mm magnets (glue in). Works without them. - 3D printed: fine layer lines are visible. PLA softens above about 55 C. - Our own design: the outer faces (fluted lid rails, chamfers, rounded grip tab, film-strip pattern on the base tab) and the 218.8 mm length. The film channels, clamp ridges, windows, magnet pockets and positioning features follow "Epson V600 35mm,120, and 110 Film Holders" by cudderbup (thingiverse.com/thing:4038305, CC BY), re-modelled by us. Not endorsed by cudderbup. Aftermarket part, not made by or affiliated with Epson.