MagSafe Desk Clamp: Desk Edge Charging Stand

My phone charges on the edge of the desk, and the desk stays empty. The MagSafe Desk Clamp is a plate that holds an Apple MagSafe charger (NOT INCLUDED)flush, carried by a 3D printed clamp that hooks onto the desk edge. The cable runs inside, two screws hide under the charger, and there's no glue. What You Need to Buy: • Apple MagSafe Charger: One, the round charger with its USB-C cable. • M5×12 Screws with a Low Head: Two, head Ø9.4 × 1.4 mm, so they hide under the charger. • M5 Heat-Set Inserts: Two. Highlights: • Charger Sits Flush: The MagSafe charger sits level with the plate. • Hidden Cable: Through the plate and down a tunnel in the clamp. The USB-C plug fits through. • Hidden Screws, No Glue: Two M5 screws under the charger. Everything comes apart. • Fits Most Desks: Desk tops from about 8 to 30 mm thick, with the plate tilted 20° back. • Portrait or Landscape: The phone snaps on upright or sideways. Clamp it to your desk, snap your phone on, and keep the top of the desk clear. Assembly: 1. Heat-set the two M5 inserts into the clamp. 2. Thread the screw into the arm from below, ball tip up, then snap the pad onto the ball. 3. Pass the charger plug through the slot in the plate and down the tunnel in the clamp. 4. Fix the plate to the clamp with the two M5 screws. 5. Press the charger into the pocket. It covers the screw heads. 6. Hook the clamp on the desk edge and tighten the knob. Design by Collecticraft